FlowerPot PanHead - Male Bowl (3108-KIT)

100% of 100
In stock
  • Works with all FlowerPot Systems 
  • Custom Fit to Your Glass
  • Grade 2 Titanium 
  • Fits 14mm or 18mm Joints
  • Made in the USA
  • Bowl Depth: .5"
  • Bowl Width: .75"

FlowerPot Pan Head Body

Glass joints aren't all made the same, so we've created the FlowerPot Pan Head - Male. You can custom-fit the AdjustaBowl to your setup and get an absolutely perfect fit on your 14mm or 18mm glass.  

How to Adjust: 

Place the 18 or 14mm post into your female glass joint, then place the Pan Head bowl on top, make sure to alighn the groove in the post with the Body handle.  When bowl is flush with your glass joint, tighten the handle until it locks the 14mm or 18mm post in place.  This should create the ideal placement, however each glass joint is unique, so you may need to adjust your post up or down slightly for the absolute perfect fit.  Once set, the Pan Head should be completely stable in the joint, with no rocking back or forth.  When removing, it should lift stright up out of the joint with zero sticking.

Alternate method:  If you need to, wrap one layer of scotch tape around the area of the post that makes contact with the glass.  The thinner the tape, the better.  Once one single layer is applied(no tape overlap) then place the post into your joint, and place the Pan Head Bowl on and secure with tightening handle.  Remove assembly from the joint, remove the tape, and should have an accurately adjusted post that is virtually garunteed not to stick.  

The premise of this design requires the bowl sits flat on top of the glass joint shutting off external air.

Exterior apperances are the only differance between the PanHead and ShovelHead Bowls.

Note:Pan Head Body includes Bowl and Post only, ShowerHead and Heater Coil, Coil cover are not included.  

Write Your Own Review
You're reviewing:FlowerPot PanHead - Male Bowl (3108-KIT)
Your Rating
" Copyright New Vape 2017 Evolving The Vape-Velope "